MKT type AIR SIGNAL
It shows flow quantity by viewing
Because use a transparent taper pipe, with a ball (or a float) and the indication red line
I can confirm approximate flow quantity by looking at the position concerned.
The installation direction does not matter
The posture when attach it as use a spring inside looks up and look down; and
I can perform sideways-facing freely.
Because use a transparent taper pipe, with a ball (or a float) and the indication red line
I can confirm approximate flow quantity by looking at the position concerned.
The installation direction does not matter
The posture when attach it as use a spring inside looks up and look down; and
I can perform sideways-facing freely.
List of models
Model
| Dimensions (mm)
| Maximum flow quantity
(L/min) | ||
Connection diameter
| Full length
| Overall width
| ||
MKT25-1TA
| Rc1/8
| 78
| 25
| 200
|
MKT25-2TA
| Rc1/4
| 78
| 25
| 200
|
MKT25-3TA
| Rc3/8
| 84
| 25
| 200
|
MKT30-2TA
| Rc1/4
| 104
| 30
| 500
|
MKT30-3TA
| Rc3/8
| 104
| 30
| 500
|
MKT30-4TA
| Rc1/2
| 110
| 30
| 500
|
In the case of an order, an estimate □Please appoint the inside of this.
Model
MKT □* -□TA | Common use flow quantity
□L/min |
An example: MKT25-2TA common use flow quantity 100L/min
※Supplement about the model
The model in case of the R screw is MKT a connection entrance exit □* -□It becomes TOA. An example: MKT25-3TOA
The model in case of the R screw is MKT a connection entrance □* -□It becomes TOMA. An example: MKT25-3TOMA
The model in case of the R screw is MKT a connection exit □* -□It becomes TMOA. An example: MKT25-3TMOA
※Supplement about the model
The model in case of the R screw is MKT a connection entrance exit □* -□It becomes TOA. An example: MKT25-3TOA
The model in case of the R screw is MKT a connection entrance □* -□It becomes TOMA. An example: MKT25-3TOMA
The model in case of the R screw is MKT a connection exit □* -□It becomes TMOA. An example: MKT25-3TMOA
Standard specifications
Fluid
| Gas
| ||
Connection
| Rc internal thread
| Change to R screw
The combination with the R screw is possible, too, | |
Heat-resistant temperature
| A maximum of 80 degrees Celsius
| -
| |
Withstand pressure
| 1MPa
| -
| |
Materials
| Transparent pipe
| Acrylic
| -
|
Coupling
| C3604 (brass)
| I can produce the product made in SUS, too.
| |
Spring
| SUS304
| -
| |
Nylon ball
| Nylon 66
| I may use a cylindrical float.
| |
O ring
| Nitrile rubber
| -
|