MKT type WATER SIGNAL
It shows flow quantity by viewing
Because use a transparent taper pipe, with a ball (or a float) and the indication red line
I can confirm approximate flow quantity by looking at the position concerned.
The installation direction does not matter
The posture when attach it as use a spring inside looks up and look down; and
I can perform sideways-facing freely.
Because use a transparent taper pipe, with a ball (or a float) and the indication red line
I can confirm approximate flow quantity by looking at the position concerned.
The installation direction does not matter
The posture when attach it as use a spring inside looks up and look down; and
I can perform sideways-facing freely.
List of models
Model
| Dimensions (mm)
| Standard specifications flow quantity
(about L/min) | Flow quantity curve list
※Standard specifications (PDF documents) | ||
Connection diameter
| Full length
| Overall width
| |||
MKT25-1TW
| RC1/8
| 78
| 25
| 1~6
| |
MKT25-2TW
| Rc1/4
| 78
| 25
| ||
MKT25-3TW
| Rc3/8
| 84
| 25
| ||
MKT30-2TW
| Rc1/4
| 104
| 30
| 3~20
| |
MKT30-3TW
| Rc3/8
| 104
| 30
| ||
MKT30-4TW
| Rc1/2
| 110
| 30
|
In the case of an order, an estimate □Please appoint the inside of this.
Model
MKT □* -□TW | Common use flow quantity
□L/min |
An example: MKT25-2TW common use flow quantity 3L/min
※Supplement about the model
The model in case of the R screw is MKT a connection entrance exit □* -□It becomes TOW. An example: MKT25-3TOW
The model in case of the R screw is MKT a connection entrance □* -□It becomes TOMW. An example: MKT25-3TOMW
The model in case of the R screw is MKT a connection exit □* -□It becomes TMOW. An example: MKT25-3TMOW
※Supplement about the model
The model in case of the R screw is MKT a connection entrance exit □* -□It becomes TOW. An example: MKT25-3TOW
The model in case of the R screw is MKT a connection entrance □* -□It becomes TOMW. An example: MKT25-3TOMW
The model in case of the R screw is MKT a connection exit □* -□It becomes TMOW. An example: MKT25-3TMOW
Standard specifications
Fluid
| Water
| ||
Flow quantity
| The reference mentioned above
| When standard specifications flow quantity or less want the above, please refer.
| |
Connection
| Rc internal thread
| Change to R screw
The combination with the R screw is possible, too. | |
Heat-resistant temperature
| A maximum of 80 degrees Celsius
| -
| |
Withstand pressure
| 1MPa
| -
| |
Materials
| Transparent pipe
| Acrylic
| -
|
Coupling
| C3604 (brass)
| I can produce the product made in SUS, too.
| |
Spring
| SUS304
| -
| |
Nylon ball
| Nylon 66
| I may use a cylindrical float.
| |
O ring
| Nitrile rubber
| -
|